Wave Solder Fixtures / Pallets
Selective Wave Solder Fixtures are a time proven method for protecting
bottomside components during the wave solder process. These fixtures keep solder
out of the mounting holes and allow for multiple soldering of thru hole components.
Special topside clamp downs are used to hold components in place during wave.
In order to minimize and eliminate defects in soldering and placement operations,
we require that the customer provide as much as possible the following information
so that we can process and manufacture your product.
Ordering information & procedures
Printed Circuit Board Information
Solder Sample - Sample Circuit Board / Bare or Loaded Board
Assembled Components Information
Component Sizes - Height / Length / Depth
Component Shapes - Resistor / Tantalum / IC
The following is required for the top and bottom side of the PCB
Specify on the P.C.B what areas (thru holes) requiring opening and closing.
Specify if specialized clamps are needed to hold down certain connectors and/or
components
Data Format
Gerber / Gerber Extended
DPF / Fire 9000
NC Info
HPGL
DXF / DWG
IGS
Required Files*
Top & Bottom Solderpaste
Top & Bottom Silkscreen
Top & Bottom Soldermask
Aperture File
Signal Trace Files
